Hammer crusher is suitable for mid-hard and light erosive materials, whose pressure resistance strength is no more than 100Mpa and humidity lower than 15%, such as coal, salt, chalk, gypsum, blocks, limestone, etc.
The main working part of hammer crusher is rotors with hammer. The rotors consist of main shaft, disk, pin shaft and hammers. The motor drives the rotors to rotate quickly in the crushing cavity.
Features of our hammer crusher:
1.The ratio of our hammer crusher is big reduction
2.our hammer crusher is of high crushing efficiency.
3.The hammer crusher is convenient to maintain.
| l |
Input size
(mm) |
Output size
(mm) |
Capacity(t/h) |
Power(Kw) |
Weight(t) |
|
PC 400×300 |
<100 |
<15 |
5-10 |
11 |
0.8 |
|
PC 600×400 |
<220 |
<15 |
10-25 |
22 |
1.5 |
|
PC 800×600 |
<350 |
<15 |
20-50 |
55 |
4.7 |
|
PC 800×1000 |
<400 |
<15 |
20-75 |
110 |
7.9 |
Ring hammer crusher main purposes:
This series of ring hammer crusher for crushing all kinds of brittle materials, such as coal, coal Chin, coke, slag, shale, limestone, such as osteoporosis. Materials does not exceed the compressive strength of 10MPa, the surface water not more than 8%.
Election winds hammer crusher used in construction materials, brick, coal, metallurgy, mining, power, light industry and other industrial sectors, for crushing coal, shale, coal, carbon, lime, cement孰料, Penghu soil and Run hard-to-brittle materials.
Described above, several sand and gravel equipment, sand production line in the system and the stone crusher production line equipment is essential.
Jaw crusher for cement, coal, power generation and building materials to meet the broken medium hardness and brittleness of materials, such as limestone, coal and so on. Maximum compressive strength of not more than 1500kg/cm2.
Hammer crusher is to use high-speed impact hammer effect on the materials and fine pieces of broken machinery operations. Articulated high-speed rotating hammer rotor, the body has a lower grate section to control the size marker. Materials into the crusher by the first high-speed movement and the initial impact of hammer crusher, and kinetic energy at the same time, high-speed toward the wall on the chassis of the broken plates and broken again. Article grate gap is less than the materials from the plane, the gap be greater than the grate in the grate be expected to block the hammer once again under the impact and grinding, until the gap was smaller than the grate be discharged.
Hammer crusher with broken than large, uniform particle size nesting, have been less crushing materials, low energy consumption. However, due to rapid wear hammer, broken in the hard materials has been limited application; another grate be afraid as a result of congestion, it should not be broken in the humidity and the material containing clay. This crusher is usually used to broken limestone, shale, coal, gypsum, chalk, etc. the following hard-brittle materials.
Will hammer crusher hammer steel ring for the ring for the coal machine, hammer crusher is the variant. It uses high-speed impact and the combination of low-speed rolling to broken materials, thus eligible for the finer products are mainly used for crushing coal for power plants, but can also be used for gypsum, salt, chemical raw materials and some materials in the broken hardware.